K Rend Thincoat Render System onto ICF Block
Summary: Silicone TC 15 onto ICF Polystyrene Insulation System with HP14 Base Coat
Substrate: ICF Polystyrene Insulation System
Primer: K Rend R10 Bonding Aid
K Rend R10 Bonding Aid should be applied in one coat application using brush or roller. Allow to cure and set.
Base Coat: K Rend HP 14 Base Coat
Apply the K Rend HP 14 Base Coat in two 3mm passes with K Rend Alkali Resistant Reinforcing Mesh embedded universally onto the surface of the first 3mm pass & overlapped 100mm all perimeters joints. Immediately follow with second pass (wet on wet application). Rule to line and level & finish the surface with a float finish smooth. Allow to cure for a minimum of 14 days.
Total Base Coat Thickness: 6 mm
Primer: K Rend Primer TC
Applied by brush or roller. Allow to cure for a minimum of 24 hours prior to application of final finish coat.
Finish Coat: K Rend Silicone TC 15
Apply by hand or machine to the thickness of largest aggregate. Allow to take up slightly prior to rubbing up to create the final texture. Surface should be rubbed uniformly to finish.
Disclaimer: The above is a high-level breakdown for a specified render system and was fully up to date and correct at the time of writing. Whilst we endeavour to ensure this page is kept up to date in line with any changes made by the manufacturer, we strongly recommend customers verify the above information directly with the manufacturer prior to a making a purchase or the application of any products and do not rely solely on the information provided above when making a decision. We accept no liability or responsibility for losses or damages occurring as a result of a customer’s failure to comply verify the above information. The render system should be applied in strict accordance with the manufacturer's instructions and specifications. These can be obtained directly from the manufacturer.
Products
