K Rend Thincoat Render System onto Render Carrier Board
Summary: K Rend Silicone TC 15 onto Cement Particle Render Carrier Board
Substrate: High Quality Cement Particle Board
Base Coat: K Rend HP12 Base
Apply K Rend HP12 Base Coat to a total thickness of 6mm. Whilst the basecoat is still wet, K Rend Alkali Resistant Reinforcing Mesh is embedded into the top third of the basecoat. Rule to line and level. Leave with a float finish. Allow to cure for a minimum of 14 days.
Total Base Coat Thickness: 6mm
Primer: K Rend Primer TC
Applied by brush or roller. Allow to cure for a minimum of 24 hours prior to application of final finish coat.
Finish Coat: K Rend Silicone TC15
Apply by hand or machine to the thickness of largest aggregate. Allow to take up slightly prior to rubbing up to create the final texture. Surface should be rubbed uniformly to finish.
Disclaimer: The above is a high-level breakdown for a specified render system and was fully up to date and correct at the time of writing. Whilst we endeavour to ensure this page is kept up to date in line with any changes made by the manufacturer, we strongly recommend customers verify the above information directly with the manufacturer prior to a making a purchase or the application of any products and do not rely solely on the information provided above when making a decision. We accept no liability or responsibility for losses or damages occurring as a result of a customer’s failure to verify the above information. The render system should be applied in strict accordance with the manufacturer's instructions and specifications. These can be obtained directly from the manufacturer.
